Monday, 26 April 2010

Exercise 8 - Camera dynamic range

I went along the River Thames and found a place in front of the restaurant. I asked my husband to sit with the white paper in his hands so I can measure the light.

The setting for the above
where there was just no highlight clipping on the white paper) was

shutter speed: 1/200"
aperture: f/6.3
ISO100
the brightness of the white paper: 1/500", f/6.3
the darkest shadow area:
a) 1/10" measuring inside the building
b) 1/50" measuring at the shadow under the chair

Using the colour sampler in Photoshop raw on 2 samples on the white paper, it shows the value of R240, G241 and B254 for both values.


Darkest shadow and after using exposure slider bar:


There are a lot of noise with the detail showing.

Calculating the range between two ends:
E.V differences (or f-stops)

where N = relative aperture
t = shutter speed

in this case N = 3.35
(i had to slide exposure up to +3.35 to see the resonable detail in the darkest shadow)

t = 1/200 sec
EV = 11.132 stops

EV varies depending on the media displaying images. Printer, DSLR, scanner, computer monitor have different dynamic range.

Thursday, 8 April 2010

Exercise 7 - Your tolerance for noise

Photos were taken against the cream-ish wall in the house with different ISO setting, 100, 200, 400, 800 and 1600 that is available in my Canon camera.
I placed the camera on tripod so I could get exactly the same images. The duration of this exercise did not take long so the lighting was very much the same. The light was from the tungsten lighting plus some outside lighting.
Post-processing, I adjusted WB to what I think was better.

Overall, I can't tell the different between these images but when I zoom in closer and compare the detail, I could see that the higher ISO (1600) contain more grain (noise) than the lower ISO (100) .

At constant aperperture, I also observed that the lower the ISO, the higher the shutter speed need to be to capture the required light in order to get correct exposure.

If the camera is not placed on tripod, with lower ISO, in the darker area, the long shutter speed will cause camera shake and that will result in blur images.

(1) ISO100 - grainy (noise) in image is less when zoom in compare to image with higher ISO


(2) ISO200


(3) ISO400


(4) ISO800


(5) ISO1600 - grainy (noise) can be seen cleary when zoom in



Monday, 5 April 2010

Exercise 6 - Highlight clipping

I chose a scene in front of Somerset House looking over Thames river. It was cloudy that day with bright spell of Sunlight.
This photo below, the highlight clipping warning has just appeared at setting ISO100, f/16, shutter speed 1/50 sec
.












Below with setting ISO100, f/16, shutter speed 1/40 sec.
The cloud was moving so the highlight clipping moved from one place to another but it does show a bit wider area of hightlight clipping.














f16, 1/60-------------------- f16 1/80 --------------------f16 1/100

The highlight clipping area is completely white, lost of visual information.



The photo above, I used recovery slider and moved it toward 100%. The highlight clipping area has disappeared and now show more detail and texture in the cloud.