a) Overall bias towards one colour in a colour photograph
(http://en.mimi.hu/photography/colour_cast.html)
b) An unwanted amount of one or more colours in an image
c) a tint of a particular colour, usually unwanted, which affects the whole of a photographic image evenly (Wikipedia)
1)"Blue" colour cast
This photo was taken during the snow. The image looks quite "blue"
JPEG
using curves and and levels layers in Photoshop CS3

RAW

adjusting with WB slide bar, exposure, contrast and some mid tone curve
Observation:
The colour cast of the same image, on JPEG, however, is more predominant while the RAW image is less.
2) Concrete surface, known "Grey"
by using curve and level in Photoshop CS

The adjusted image above is not the same as the real image but it does look sharp and nicer!
This image was taken with compact camera therefore has no RAW image!
3)Snowman under tungsten lighting (Orange-ish)
Using Photoshop CS3 with Colour balance layer,
(OK-ish) Using WB slide bar, tint slide bar and some minor adjustment of contrast
Conclusion:
Colour cast can be removed/adjusted from RAW image much easier using software (raw converter) with more accurate colour and without lost of detail.
However Colour cast can also be removed from JPEG image at an accpetable colour faster using photoshop but with lost of quality.
The acceptable level of the colour cast does really depend on a personal taste.
An image with certain colour sometimes give the viewer a different feeling altogether.
No comments:
Post a Comment